Basic Wig Guide

Here are 3 simple steps to measure your head inaway from the label if you need to loosen it.
order to determine your wig cap size:7) Style as you would your own hair, keeping in
Before you measure, make sure to flatten yourmind to be gentle with the hair. Most wigs will
hair. This will help take into consideration the factrequire some cutting and styling to create the
that you will probably be wearing a mesh wig capindividual wearer's desired effect. A professional
liner beneath your wig for a more comfortablewig stylist who can help you achieve your look
and secure fit. Use a cloth measuring tape, beingand teach you how to use various approved wig
sure not to pull the tape measure too tight. Justcare products is preferred. Remember, you would
rest the tape over or around your head. Pullingbe best to take off too little than too much as it
the tape measure too tight will stretch the tapewill not grow back.
and will not give you an accurate measurment.Styling and Maintenance of Your Wig.
While it is important to get an accurate1) Cleaning Your Wig:
measurement to determine your wig cap size,- Brush the wig thoroughly, remembering not to
keep in mind that most wigs have tabs whichpull too hard on the hair fibers.
allow up to one inch of adjustment for a more- Fill your sink or basin with cold or luke warm
secure fit.water, adding shampoo specifically designed for
1) Measure Around Your Head: Measure the totalsynthetic hair, or shampoo for color treated hair.
distance around your head starting at your natural- Let your wig soak for 5-10 minutes. You can
hairline in the front, to just above your ears, andmove the wig around in a gentle motion, but do
around the back to the bend of your neck and tonot rub it.
the front of your head.- Rinse in cold or luke warm water until thoroughly
2) Measure Front to Back: Bend your head back.rinsed.
Then measure from your natural hairline in the- Generously apply conditioner to the wig, working
front of your forehead, back over the crown toit through with fingertips.
the bend where your head meets the top of- Rinse again until all conditioner is removed from
your neck.the wig.
3) Measure Ear to Ear: Measure at the top front- Gently blot the wig with a towel. Do not rub.
of one ear, lay the tape measure up and over- Run your fingertips through the wig fibers
the crown of your head to the same position onwithout pulling to loosen any tangles or knots.
your other ear.- Place the wig on a wig stand to air dry. If the
The 3 measurements listed above will determinewig is human hair, you can use a blow dryer, but
the circumference, the depth and width of yourit is recommended you use a wig stand as well to
wig cap and allow you to choose your correctpreserve the wigs longevity.
size.2) Styling of Synthetic Wigs:
The following sizes should be used as a guide only,- If upon receiving your wig, you find you need it
as cap sizes may vary by manufactorer.altered or restyled, it is advised you take it to a
*Head Size - Child: (19" Around the Head) (12"professional stylist to achieve the desired effect.
Front to Back) (12" Ear to Ear).Do not fuss with the styling of a synthetic wig, as
*Head Size - Petite: (21" Around the Head) (13most often a simple shake it and go method
¼" Front to Back) (13" Ear to Ear).works just fine. Hence, these were made
*Head Size - Petite/Average: (21.5" Around thespecifically for ready to wear. You can of course,
Head) (13 3/4" Front to Back) (13 1/4"Ear to Ear).clip and pin different sections to your liking for a
*Head Size Average: (22" Around the Head) (14 1change of style, but as you get used to the wig,
4" Front to Back) (13 1/4" Ear to Ear).you will most likely find that you do not have to
*Head Size Average/Large: (22.5" Around thedo anything if at all in maintaining it's style. For
Head) (14 3/4" Front to Back) (13 3/4" Ear tocurly wigs, use a pick or comb to loosen fibers,
Ear).but do not pull on the hair.
*Head Size Large: (23" Around the Head) (15 1/4"3) Styling of Human Hair Wig:
Front to Back) (14" Ear to Ear).- If upon receiving your wig, you find you need it
How To Put Your Wig On.altered or restyled, it is advised you take it to a
1) Take the wig out of the box, shake it gentlyprofession stylist to achieve the desired effect.
to loosen fibers.After air drying or using a blow dryer with the
2) Find the front and the back of wig (rememberhair completely dry, use a wider tooth comb or
the label goes in back).brush, starting at the ends and working your way
3) Brush your own hair back, securing any longerup to the roots. Remember it is human hair, and it
pieces with a hair pin and place a wig cap overtoo can get split ends if not treated delicately.
your head (keeps your existing hair from fallingPlace the wig on it's wig stand and use hot rollers
and the wig securely in place.or a curling iron on a low setting to style the hair
4) Grasp the wig at the top and slip it over yourto your liking.
head from hairline to back.4) Storing Your Wig:
5) Adjust wig so that the edges meet with your- Store your wig on a wig stand in a clean, damp
own natural hairline.free and heat free environment. This will ensure it
6) The wig should feel secure but no too tight. Ifstay tangle and soil free between wearing, as well
necessary, adjust the back elastic straps withas maintain the wig's style.
hooks toward the inner label for tightening, and